Home page

In the use of permanent magnet DC gear motor need to pay attention to what

1. in the use of permanent magnet DC gear motor need to pay attention:

1. Low speed, high torque models to take the current limiting protection method to prevent the occurrence of blocking caused by the damage to the gear reducer;

2. When the motor reverses instantaneously, it will produce a large current, which will affect the life of the motor. Frequent commutation should be switched when the motor is completely stopped;

3. If it is difficult to avoid blocking in use, please tell the company in advance and take necessary measures;

4. When using the remote control to control the interference signal of the motor, a capacitor of 0.1uF(63V) can be welded between the positive and negative poles during installation, and the negative pole is grounded;

Permanent magnet DC motor low stall torque is rated torque 5-6 times, in the installation, commissioning, use should try to avoid the stall phenomenon.

2. in the selection of permanent magnet DC gear motor need to pay attention:

1. The selected motor shall be tested on the prototype before batch use to confirm whether the rated speed, rated torque, voltage and current are suitable. If it is close to the standard, the selection can be considered reasonable and can be used. If the deviation is large, it is necessary to change the type, otherwise the service life and quality cannot be guaranteed;

2. Reasonable selection of the basic conditions of the gear motor, is the rated voltage, rated speed, rated torque three indicators;

3. The high efficiency point in the performance index introduced in the parameter table of each model refers to the rated speed and rated torque, which are selected for reference. The rated working point of the gear reducer motor is an important basis for motor design. When working near the rated point, it has high working efficiency and stable performance;

4. Under the condition of large deceleration and low speed, refer to the allowable load and speed in the performance parameter table. Running under the condition of allowable load and speed will reduce the service life of the reducer or directly damage the gear reducer.

3. in the installation of permanent magnet DC gear motor need to pay attention to are:

1. The accessories installed on the output shaft of the gear reducer shall not be knocked down hard to avoid excessive up and down movement. When installing the circular gear box, control the length of the mounting screw. If the screw is too long, it will kill the internal structure of the box;

2. Do not screw the reducer directly at the output end, which may cause damage to the internal gear;

3. Before installing the machine, power on and try to check whether the performance meets the requirements before installation. Do not disassemble the reducer by yourself, so as not to affect the noise and quality;

4. The lead wire is not enough to pull hard, and the terminal should not be impacted and bent, otherwise it will cause poor internal conductivity;

5. The welding wire end of the motor should be completed before the machine is put on. The welding wire should use suitable electric soldering iron and soldering tin. The operation should be skilled, fast and accurate. Generally, 40W soldering iron is recommended. The temperature of the soldering iron tip is about 320±20 degrees and the welding time is 2-3 seconds. Welding time is too long will cause the motor internal desoldering, resulting in poor power.

Related News